Motorcycle Rail/Ramp Kit, Assembled Rail and Wheel Block Size: 5" W x 2-3/8 H x 73-1/2 L, Can be mounted on almost any flat trailer bed with minor amount of drilling. Includes assembly and mounting hardware. Ideal for dirt bike, scooter, or small street motorcycle.

Motorcycle Rail/Ramp Kit, Wheel Block and Front Rail Section: 6-1/2" W, Rear Rail Section and Ramp: 8' W, Assembled Rail with Wheel Block: 86" L, Rail Height: 2-3/8, Adjustable Wheel Block Placement, Includes Storage Brackets For Ramp. The rail sections are 86-1/2" long from the front of the wheel block to the end of the rail when the two rail sections are overlapped and bolted together. The front and rear sections may be mounted separately in order to haul a very long motorcycle on a trailer or truck bed that is long enough to support the wheelbase of the motorcycle.

The R2 Motorcycle Rail Kit includes an adjustable position wheel block, 6-1/2" wide by 41-1/2" front rail section, 8" wide by 39-1/2" rear rail section, and mounting hardware. The rail sections and wheel block are made of 3/16" steel with black powder coat enamel. This is same as TS76M, but does NOT include a ramp.

The R1 motorcycle ramp fits into our 8" wide motorcycle rail kits or can be used with any flat surface where there is a hole for the mounting stud. It is made of 3/16" steel with black powder coat enamel. This ramp is ideal for dirt bikes and motorcycles that are not too long and have good ground clearance. It will support motorcycles weighing up to about 600 lbs. For sport bikes see the EK1

To add the optional storage brackets and hardware ($15), select the Storage Brackets and Hardware option when adding this product to the cart.

The EK1 Motorcycle Ramp and Extension Kit is designed for sport bikes where ground clearance is very low due to lower and front fairings. It breaks the angle in half at the top of the ramp (apex) so that the motorcycle does not bottom out when loading and unloading. The ramp will handle a motorcycle with up to about 58" wheelbase weighing up to 500 lbs with rear tire width up to 8". Overall length is approximately 66".

The EK1 includes a 21-1/4" lower ramp, fold-up support brackets, and a 44-1/2" long upper ramp. The upper ramp is same as the R1 ramp, but the edges at top and bottom are lowered for extra clearance. The ramps are 3/16" steel with black enamel. The brackets are 14 guage zinc plated steel.